Advanced Audio CM47 large dual-diaphragm, multi-pattern, tube condenser microphone
Sold Out
Advanced Audio CM47
The Advanced Audio CM47 is a large dual-diaphragm, multi-pattern, tube condenser microphone inspired by the famous Neumann U-47. The CM47 is a great choice for vocals, saxophones, acoustic instruments, and excels in front of bass and guitar amps.
Maria Bobone using the CM47 on her beautiful vocals. You can also hear the CM1084 being used on the Portuguese guitar track.
The CM47 was recently used on legendary singer/songwriter John Oates in Nashville engineered by our good friend Joe Carrell.
Capsule:
The Advanced Audio CM47 features our very accurate and smooth AK67 capsule, a 35mm capsule with 6-micron-thick German mylar diaphragms. Its frequency response falls between those of the U47 and U67 vintage tube microphones. The AK67 capsule goes down another ½ octave before rolling out, compared to the K47 capsule. The CM47 also has more “air” or “sizzle” above 10kHz, allowing it to cut more easily through busy mixes without the addition of EQ.
Circuit:
The circuit is designed around the very HiFi 6072 tube and optimized with a two-stage Class "A" CCDA circuit.
This circuit provides a much lower output impedance with more headroom than the original circuit used in the original U47. The lower output impedance provides a faster damping factor when driving the BV8 type transformer, delivering a better transient response than the original design.
Selected 6072a tubes are some of the quietest tubes made, and are much less susceptible to microphonics than the metal-clad vf14 tubes used in the original U47 tube microphone.
The dual-bobbin output transformer with its hum bucking configuration and our optimized circuit will deliver > +14dBu with less than 1% distortion.
The output transformer is driven with a 2.2 ufd metal-film capacitor to take advantage of the transformer’s response down below 20Hz.
Specifications:
1.07” (35mm) Ak67 dual back plate, dual 6-micron skinned mylar capsule Capsule polarization 60v on the back-plate.
9 selectable pickup patterns remotely switched from the power supply
Dual bobbin BV8 (6.5:1 ratio) output transformer
Selected 6072a tube Class A dual stage (CCDA)
Frequency response: 20Hz to 20kHz +/–3dB
Noise: <15dB (A-weighted)
Impedance: < 200 ohm (load impedance <1.2K)
Distortion: < 0.5% @128dB
Maximum Output: > +14dBu with less than 1% distortion
Robust shock mount that threads onto microphone body
Not bad but needs time spent to get the most out of it.
Much of the default samples are very thin and I get that it's based on the original hardware though some options in the plugin would have been nice but not necessary. General operation is good both as plug in and stand alone with some excellent features. Auto fills work nicely. Looking forward to spending some more time with it to get the most out of it.
These are a fantastic solid stand. I have my. Adam A77h’s on them . However, if I’m wrong cable management would be a blessing on the back but have been to the hardware shop to get some cable clips.
