Handheld vocal microphones have a certain look for both historical reasons as well as for the fact that they need to meet certain audio needs. Having a steady handgrip and controlled wind- and pop-suppression is exceptionally important.
Both of these basic needs require space in and on the unit, so companies must ensure that the shape of the vocal microphone is ergonomically-designed for the average hand. For most efficient wind- and pop-suppression, the furthest distance of the internal diaphragm from the mouth as possible is ideal, which requires a certain grill size. At the same time, the overall size of the stage vocal microphone must be bigger than a small diaphragm condenser recording microphones and smaller than a large diaphragm cylinder “bird cage” studio microphone. For the performer, it should also appear to be large enough to “hide” behind (like having an instrument), but also small enough to provide a view that enables them to move around the stage and the audience to see them.
Specifications
| Directional pattern: |
Supercardioid |
| Principle of operation: |
Pressure gradient |
| Cartridge type: |
Pre-polarized condenser |
| Frequency range: |
20 Hz – 20 kHz |
| Frequency range, ± 2 dB, at 12 cm (4.7 in): |
100 Hz – 16 kHz with 3 dB soft boost at 12 kHz. Permanent 3rd order low-cut filter (-3 dB at 80 Hz). |
| Sensitivity, nominal, ± 2 dB at 1 kHz: |
5 mV/Pa; -46 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: |
Typ. 19 dB(A) re. 20 µPa (max. 21 dB(A)) without attenuation |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): |
Typ. 75 dB(A) |
| Total Harmonic Distortion (THD): |
< 1 % up to 139 dB SPL peak |
| Dynamic range: |
Typ. 120 dB
|
| Max. SPL, peak before clipping: |
160 dB |
| Switchable attenuator: |
0 dB / -10 dB |
| Output impedance: |
< 100 ohm |
| Minimum load impedance: |
1 kohm |
| Cable drive capability: |
100 m (328 ft) |
| Output balance principle: |
Impedance balancing with Active Drive |
| Common Mode Rejection Ratio (CMRR): |
> 50 dB at 1 kHz |
| Power supply (for full specifications): |
48 V Phantom power (± 4 V) |
| Current consumption: |
Max. 5 mA |
| Connector: |
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: – phase |
| Color: |
Matte black |
| microphone weight: |
245 g (8.6 oz) |
| Microphone diameter: |
50 mm (2.0 in) |
| Capsule diameter: |
19 mm (0.75 in) |
| Microphone length: |
195 mm (7.7 in) |
| Output voltage, RMS: |
> 5 V |
| Polarity: |
+V at pin 2 for positive sound pressure |
| Temperature range: |
-40 °C to 45 °C (-40 °F to 113 °F) |
| Relative Humidity (RH): |
Up to 90% |
$89.00 AUD
$399.00 AUD
$459.00 AUD
